Embedded Files
TURN ON BUBBLES
To turn on the spa:
Place finger on the lock/unlock button for 3 seconds until it beeps.
Press the Massage system button.
Press the up and down button to adjust the heat.
Note: The temperature can be displayed in either Fahrenheit or Celsius using the "Thermostat button"
**DO NOT TURN OFF THE POWER**
THESE 3 LIGHTS MUST BE ILLUMINATED ON THE SPA PUMP AT ALL TIMES.
Turning off the spa may result in a reheating fee.
RESTART INSTRUCTIONS IN CASE THE POWER TO THE PUMP IS SHUT OFF.
1. Press POWER (middle) button for 2 seconds to active the control panel buttons, and the light turns green.
2. Press the Water Filter button (right). The light above the Water Filter Button displays Red when activated.
3. Press the Water Heater button (left). When the light above the heat button is Red or Green, the heating system is activated.
4. Press the Celsius/Fahrenheit button. When the light above the heat button is red, the heating system is activated.
5. Press the button to 100 degrees Fahrenheit or 37 degrees Celsius.
6. *PLACE COVER BACK ON SPA* after use to prevent bugs and pest from entering.
7. MORE DETAILED INSTRUCTIONS ARE LOCATED ON THE WALL NEXT TO THE SPA
(Note: If power has been off for a great deal of time and energy, it will take at least 5 hours for the water to heat to the recommended temperature above)
IF THE POWER ON THE SPA WILL NOT COME ON AFTER PUSHING THE POWER BUTTON.
GO TO GARAGE AND LOCATE THE GFCI OUTLET ON THE WALL. (PICTURE IS BELOW)
PUSH THE RESET BUTTON. (THE CIRCUIT WAS TRIPPED)
POWER SHOULD BE RESTORED OUTSIDE IN THE SPA AREA.
GO BACK AND FOLLOW THE RESTART INSTRUCTIONS ABOVE.
Page updated
Google Sites
Report abuse